Page 1 of 1
XRT600
Posted: Wed Sep 08, 2010 11:34 am
by EVguru
Re: XRT600
Posted: Wed Sep 08, 2010 11:52 am
by oekotopia
Hi,
looks rather invisible
Georg
Re: XRT600
Posted: Fri Sep 10, 2010 2:43 pm
by oekotopia
This time the pictures appeared,it looks
realy good exept those orange plastic parts,
whats about the back side indicators,don't
you need them in UK?
On my bike I've changed the pinnion to 17 teeth
and the crown to 42,its a bit less speedy but it runs
about 120 km/h at 5200 rpms and goes up till 150 km/h.
best regards
Georg
Re: XRT600
Posted: Fri Sep 10, 2010 4:53 pm
by Joachim
oekotopia wrote:
This time the pictures appeared
Maybe you have not been loged in the first time.
exept those orange plastic parts,
Some blue paint would do that
On my bike I've changed the pinnion to 17 teeth
uups... 17??? Shure?
I only have seen 14, 15 and sometimes 16. If i remeber right.
ciao joachim
Re: XRT600
Posted: Fri Sep 10, 2010 9:43 pm
by EVguru
It's fitted with a tiny pair of rear indicators. When I get up into the workshop roof this weekend to dig out some Morini Dart parts to send to Denmark, I'll have a look through my box of indicators. I think I have a pair of Kanguru ones that would be more appropriate. It's going to get a service, including the all important cambelt change, whislt I wait for the paperwork to catch up with me.
Re: XRT600
Posted: Sat Sep 11, 2010 8:51 pm
by oekotopia

Hello,
J
oachim wrote:uups... 17??? Shure?
I only have seen 14, 15 and sometimes 16. If i remeber right.
I was Shure until I read your not,
I'll have to count an then write it into my Workshop-
manual so I can never forget it.
Sometimes it's hard getting old.
Georg