gileraclub.de

I bought new parts:


Kevlarbelt polini
Tecnigas pipe
Polini membrane
28mm carb
Polini variator
Malossi delta clutch

and ported original cylinder
cylinder is push down 0,7mm and ... sorry my English.
At stay 13100rpm

We take missteke.. 2stroke oil goes kevlar and all parts when I drive.
Now Is cleaned, but I think it goes about 7,5-8,5 sec 0-100.
It should goes a lot of much better, maybe at least about 6sec 0-100?
Machine is good, but Power don`t go to back tyre...
I am desperate!!!

Now I think kevlar slide or Is polini bad?!
Is kevlar burned???
What I have to do?

It does`t lift up front tyre.. maybe a little bit , when it is could, not when in motion only fron starting zero... could.
Whith high rmp not at all.

This goes better, then mine, is it possible?
http://www.datenoase.de/kuifje/engl/menu.html

It should go much better!!!