Page 1 of 1
Starter Clutch
Posted: Sat Mar 18, 2006 2:07 pm
by moggyvan
I am about to embark on the journey into the unknown that is the slipping starter clutch. Is it a fairly straightforward job, and is there anything i should be wary of? I have the tool for pulling off the gen. rotor but will i need any other special tooling? Thanks in advance. Mick.......
Posted: Sun Mar 19, 2006 5:04 pm
by moggyvan
.........For a Nordwest!
Posted: Sun Mar 19, 2006 5:37 pm
by gileramad
No - you don´t need any other special tools. Do you want to simply replace it or do you want to repair the old one?
Posted: Sun Mar 19, 2006 9:00 pm
by kenthetuner
Hi, The unkown
I am about to do the same job
. I have made the flywheel generator puller. What is involved in repairing rather than replacing the starter clutch?
The only thing holding me back at present is this cold spell here in england my workshop is not heated.
Posted: Mon Mar 20, 2006 5:57 am
by moggyvan
I have bought the outerace and the 'sprag' roller assembly from Bob Wright. If i can repair it whilst the bike is in bits i will though......
Posted: Mon Mar 20, 2006 10:08 pm
by gileramad
You can also DL the manual @ christoph's website ->
http://www.rc600.de/html/anleitungen.html
Written in german but with some pictures that may help.
Posted: Wed Mar 22, 2006 8:16 pm
by moggyvan
All done and back together. Total time on the job was probably only around 5 hours. Not too bad really. Turns over nicely now! Cheers Bob and the guys!!